Launch X431 PAD 5 Test Report: Perform Special Function on Different Cars

2022/3/6 23:17:34

本文主要是介绍Launch X431 PAD 5 Test Report: Perform Special Function on Different Cars,对大家解决编程问题具有一定的参考价值,需要的程序猿们随着小编来一起学习吧!

Launch X431 PAD V is a comprehensive automotive diagnostic tool. It not only supports intelligent diagnosis, local diagnosis and remote diagnosis, but also can do 16 kinds of special functions, including ELEK. Gas relearn CVT oil pressure calibration, steering angle reset, DPF, ABS bleed, battery calibration, injector coding, etc. Check out the reviews below to see exactly what it can do.
Launch X431 PAD 5 Test Report-1 (2)

1.Register new ECM VIN for Nissan X-Trail
– Write the VIN to NISSAN X-TRAIL new ECM
(e.g. Nissan X-Trail T32 2017)

Select “Diagnosis” -> “Nissan”-> “Full system diagnosis”-> “The vehicle with 16 OIN”-> “System Selection”-> “Engine”-> “ECM (Engine Control Module)”

Start scanning ECM
Then tap “ECM (Engine Control Module)- Equipped”
Launch X431 PAD 5 Test Report-2 (2)
Select “Special Function”-> “VIN registration”
Confirm ignition switch is on and engine stopped. Hold these conditions during the procedure.
Launch X431 PAD 5 Test Report-3 (2)
Select “VIN READ”-> “Input” to input the VIN of the vehicle
Then Select “VIN WRITE”-> “Input” to input the VIN again
Launch X431 PAD 5 Test Report-4 (2)
Command succeeded
Turn ignition switch off for 10 sec and then turn on to confirm no DTC
Launch X431 PAD 5 Test Report-5 (2)
VIN write system info

Select “Module information”-> “VIN registration”
The VIN number appears on the screen now. It has been registered successfully.
Launch X431 PAD 5 Test Report-6 (2)
2.Reset electric throttle relearn for TOYOTA
Select “Reset”-> “ELEC. THROTTLE RLRN”-> “TOYOTA”
Switch ignition on
Read out VIN
Select “Automatic” to read VIN and mode info
Launch X431 PAD 5 Test Report-7 (2)
Select “Learning Value Reset” to reset all learned values related to engine operation
Read the on-screen instruction and start resetting
Reset learning value successfully
Launch X431 PAD 5 Test Report-8 (2)
3.EPS (Electronic Power Steering) on BMW 320i (2015) F30
Select “Diagnosis” -> “BMW”-> “Automatically search”-> “Health Report” to read fault codes
Launch X431 PAD 5 Test Report-9 (2)
Then clear fault code

Launch X431 PAD 5 Test Report-10 (2)
Check trouble code again
The EPS fault code still appears
Go to select “Fault Guidance”
Select the related fault code and click “Fault Guidance”
Launch X431 PAD 5 Test Report-11 (2)
Read the fault guidance carefully and follow it to operate step by step
Launch X431 PAD 5 Test Report-12 (2)
Launch X431 PAD 5 Test Report-13 (2)
Read fault code again, now there is no fault code.
Launch X431 PAD 5 Test Report-14 (2)
www.cnautotool.com



这篇关于Launch X431 PAD 5 Test Report: Perform Special Function on Different Cars的文章就介绍到这儿,希望我们推荐的文章对大家有所帮助,也希望大家多多支持为之网!


扫一扫关注最新编程教程